[sdiy] Eurorack Power Protection

Roman Sowa modular at go2.pl
Wed Jan 4 11:43:45 CET 2017


No, it's not. If you use 10R resistor, make sure it's small enough 
(powerwise) that it will burn open in short time when connected to 12V 
supply. This will act like a fuse then.

Roman

W dniu 2017-01-04 o 03:39, Jacob Watters pisze:
> Ok thanks. And is it ok to replace the fuse with a 10R resistor?
>
> On Tue, Jan 3, 2017 at 9:38 PM, matt holland <matt at mattholland.org
> <mailto:matt at mattholland.org>> wrote:
>
>     I don't see any reason how that could possibly harm any other
>     modules in a system.
>
>     On Tue, Jan 3, 2017 at 6:20 PM, Jacob Watters
>     <jacobwatters at gmail.com <mailto:jacobwatters at gmail.com>> wrote:
>
>         I was told that the Blacet configuration might harm other
>         modules in a system that do not have the same protection. Is
>         that correct?
>
>         http://blacet.com/techPS.gif
>
>         On Tue, Jan 3, 2017 at 8:51 PM, <blacet at blacet.com
>         <mailto:blacet at blacet.com>> wrote:
>
>             Check out the "Tech Corner" on the blacet website.
>
>
>             ------- Original Message ----------
>
>              I have a "few years" experience using the reverse diode to
>             ground/polyfuse system. Add caps as you wish. Never had a
>             burnt out
>             pcb---never. Which polyfuses are you using ? There's a lot of
>             choice... Cheers, Colin f
>
>
>             _______________________________________________
>             Synth-diy mailing list
>             Synth-diy at synth-diy.org <mailto:Synth-diy at synth-diy.org>
>             http://synth-diy.org/mailman/listinfo/synth-diy
>             <http://synth-diy.org/mailman/listinfo/synth-diy>
>
>
>
>         _______________________________________________
>         Synth-diy mailing list
>         Synth-diy at synth-diy.org <mailto:Synth-diy at synth-diy.org>
>         http://synth-diy.org/mailman/listinfo/synth-diy
>         <http://synth-diy.org/mailman/listinfo/synth-diy>
>
>
>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>



More information about the Synth-diy mailing list