[sdiy] Eurorack Power Protection

Jacob Watters jacobwatters at gmail.com
Wed Jan 4 03:39:27 CET 2017


Ok thanks. And is it ok to replace the fuse with a 10R resistor?

On Tue, Jan 3, 2017 at 9:38 PM, matt holland <matt at mattholland.org> wrote:

> I don't see any reason how that could possibly harm any other modules in a
> system.
>
> On Tue, Jan 3, 2017 at 6:20 PM, Jacob Watters <jacobwatters at gmail.com>
> wrote:
>
>> I was told that the Blacet configuration might harm other modules in a
>> system that do not have the same protection. Is that correct?
>>
>> http://blacet.com/techPS.gif
>>
>> On Tue, Jan 3, 2017 at 8:51 PM, <blacet at blacet.com> wrote:
>>
>>> Check out the "Tech Corner" on the blacet website.
>>>
>>>
>>> ------- Original Message ----------
>>>
>>>  I have a "few years" experience using the reverse diode to
>>> ground/polyfuse system. Add caps as you wish. Never had a burnt out
>>> pcb---never. Which polyfuses are you using ? There's a lot of
>>> choice... Cheers, Colin f
>>>
>>>
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at synth-diy.org
>>> http://synth-diy.org/mailman/listinfo/synth-diy
>>>
>>
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at synth-diy.org
>> http://synth-diy.org/mailman/listinfo/synth-diy
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20170103/5dd5c8ce/attachment.htm>


More information about the Synth-diy mailing list