[sdiy] Eurorack Power Protection

[Vladimir Pantelic]

On 03.01.2017 23:35, Jacob Watters wrote:
> Thanks for all of the feedback so far. Here are my notes:
>
> Boxed Header
> This is what I plan to use. Maybe my pin umbers are off. I was going by the
> image linked below. Is pin 1 on the bottom right in this image?
>
> http://www.doepfer.de/a100_man/a100b_e.gif

pins 1 and 2 of a 10/16 pin boxed/shrouded header are -12V and should be 
oriented towards the bottom of a module. the actual header will have a little 
triangle mark there, as will the IDC connector that plugs into it - that's where 
you put the red stripe of the ribbon cable.