[sdiy] New device, weird midi behavior

Jacob Watters jacobwatters at gmail.com
Sun Dec 31 02:20:38 CET 2017


Maybe the MIDI is running on 3V  instead of 5V and isn't able to pass the
trigger threshold on some devices.

Maybe there is noise in the usb power. Try another power source and a cable
with ferrite.

On Dec 30, 2017 8:04 PM, "Joel B" <onephatcat at earthlink.net> wrote:

> I have this new device, a kickstarter product, it is USB Powered, and it
> only works well with a few of my synthesizers. For others it seems to send
> nothing at all, others it makes them stop making any sound at all while
> plugged in, as if it is sending a stream of all notes off.  In my emagic
> midi interface it either sends nothing, or, on another Unitor 8 in the
> Unitor daisy chain it sends bank select 0 every so often. Plugged into an
> old Opcode midi interface it seems to send proper note on off though. Seems
> to work ok on Roland JX8p and Yamaha tx816... not on DX7 though. Korg
> Minilogue but not sequential max.  Seems to send proper midi data to my
> iconnectMidi1 for iOS.
>
> Same keyboards and interfaces all respond properly to other midi sources.
> So I’m thinking something electrical is wrong here?
>
> What would you investigate to try to understand what is going on?
>
> Any hypotheses?
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20171230/0f19fea7/attachment.htm>


More information about the Synth-diy mailing list