[sdiy] 2164 outputs

Tim Ressel timr at circuitabbey.com
Fri Aug 25 21:40:04 CEST 2017


Got it. Thanks folks!


On 8/25/2017 12:11 PM, Olivier Gillet wrote:
> Short answer: No. It will work to some extent with a fairly low
> resistor (keeping the output voltage within +/- 100 mV).
>
> On Fri, Aug 25, 2017 at 8:37 PM, Tim Ressel <timr at circuitabbey.com> wrote:
>> Hi,
>>
>> So the datasheet for the 2164 shows the output always routed to an inverting
>> opamp configured as a current to voltage convertor. Is it possible to
>> configure the 2164 output with a resistor to ground and a non-inverting
>> opamp buffer? I am trying to have an opamp package.
>>
>> Thanks!
>>
>>
>> --
>> --Tim Ressel
>> Circuit Abbey
>> timr at circuitabbey.com
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at synth-diy.org
>> http://synth-diy.org/mailman/listinfo/synth-diy
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy
>

-- 
--Tim Ressel
Circuit Abbey
timr at circuitabbey.com



More information about the Synth-diy mailing list