[sdiy] 2164 outputs

[Olivier Gillet]

Short answer: No. It will work to some extent with a fairly low
resistor (keeping the output voltage within +/- 100 mV).

On Fri, Aug 25, 2017 at 8:37 PM, Tim Ressel <timr at circuitabbey.com> wrote:
> Hi,
>
> So the datasheet for the 2164 shows the output always routed to an inverting
> opamp configured as a current to voltage convertor. Is it possible to
> configure the 2164 output with a resistor to ground and a non-inverting
> opamp buffer? I am trying to have an opamp package.
>
> Thanks!
>
>
> --
> --Tim Ressel
> Circuit Abbey
> timr at circuitabbey.com
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy