[sdiy] IDC, Pin Headers, Ribbon Wire: Where to start?

[Matthias Herrmann]

If you use IDC connectors someone in the huge Eurorack community might probably connect the power to it. No matter how clearly you label it.

 

You could use Micromatch(TM) connectors instead, the work with standard ribbon cables, too.

 

Cheers,

Matthias

 

Von: Synth-diy [mailto:synth-diy-bounces at synth-diy.org] Im Auftrag von Youssef Menebhi
Gesendet: Dienstag, 22. August 2017 06:29
An: synth-diy at synth-diy.org
Betreff: [sdiy] IDC, Pin Headers, Ribbon Wire: Where to start?

 

Greetings, 

 

I found this list while searching for answers to this question, so I hope that I've come to the right place.

 

I prototype circuits on standard blank PCB - but have never learned very much about organized fabrication. I would like to come up with a simple solution to use 10-pin ribbon wire to connect boards together. I am very uncertain about the standard sizes, terminology, and best practices, though. Would people here be willing to share some of their methods? 

 

Sincerely,

Youssef 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20170822/873deb44/attachment.htm>