[sdiy] SSM chip reissue

[Tony Kalomiris]

This is probably premature, but am anxious to get back into electronic design and construction again
- after spending way too much time with uC code, but any word if us hobbyists and synth enthusiasts 
are going to be able to get these in small quantities?
I would be surprised if the big parts houses don't carry these in their line up

I just studied the datasheet and am pretty anxious and inspired.
This SSOP and chip tempco will also be an incentive to do some smt work. 
The site does mentions a pdip outline however, so I will wait;)


TK


On 2017-04-27, at 6:18 AM, Colin f wrote:

> 
>> -----Original Message-----
>> From: Terry Shultz [mailto:thx1138 at earthlink.net]
>> Sent: 24 April 2017 19:14
>> Subject: Re: [sdiy] SSM chip reissue
> 
>> It appears that Dan Parks may be involved (AKA Cruz Tools) and former
>> President of SSMT.
>> 
>> Not sure who else would be involved unless Dave Rossum was re-engaged
>> on the Filter design possibly.
> 
> Dave did the filter design.
> Dan is the man behind the whole thing. Dave gave me Dan's card but it's
> misplaced somewhere in a pile of Superbooth stuff atm...
> 
> Cheers,
> Colin f
> 
> 
> 
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy