[sdiy] Chip pins/legs for DIY drop-in DIP

[rsdio at audiobanshee.com]

Thanks. These are certainly better than square headers pins, which are too large for most IC sockets. However, what's wrong with the tried and true milled round pins that are available in strips? I haven't sourced them in a while, but I used to buy them in strips and just cut the number of pins needed in each row. Very safe for breadboards or sockets and they don't bend.

These Flip Pins sure look fancy, but it seems that they'd be as fragile as standard IC pins - which is to say, too fragile.

Brian


On Sep 15, 2016, at 5:57 PM, MTG <grant at musictechnologiesgroup.com> wrote:
> This was brought up a long time ago, but the short comment is that someone finally delivered. Check these out if you make any type of PCB that pops into a socket or breadboard:
> 
>    http://oshchip.org/products/Flip-Pins_Product.html
> 
> GB