[sdiy] Moog Etherwave - Mic mount flange - Where to get in Europe?

[sleepy_dog at gmx.de]

D'oh! That makes sense :-D

Am 02.09.2016 um 22:58 schrieb Florian Anwander:
> Hello
>
>> I have to say, it looks a bit brutal, what it does to the wood.
> You don't hammer it in. I found the english word "drive-in nut". This 
> describes it better:
>
> You simply drill a hole, then insert the nut until the spikes sit on 
> the wood, then you insert a suitable screw with a wide washer from the 
> other side, and finally you tighten the screw. The screw will pull (or 
> better: draw?) the nut with the spikes into the wood. There is no 
> splicing, no trashing. I use those all the time to mount wheels to my 
> cheapo Thomann-cases.
>
> If you are in doubt, then test it with another piece of wood.
>
> Florian
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>