[sdiy] Moog Etherwave - Mic mount flange - Where to get in Europe?

[Florian Anwander]

Hello

> I have to say, it looks a bit brutal, what it does to the wood.
You don't hammer it in. I found the english word "drive-in nut". This 
describes it better:

You simply drill a hole, then insert the nut until the spikes sit on the 
wood, then you insert a suitable screw with a wide washer from the other 
side, and finally you tighten the screw. The screw will pull (or better: 
draw?) the nut with the spikes into the wood. There is no splicing, no 
trashing. I use those all the time to mount wheels to my cheapo 
Thomann-cases.

If you are in doubt, then test it with another piece of wood.

Florian