[sdiy] PC board from artwork?

[Paul B]

Other than mfos and yusynth and foniks archive, are there any suggestions for sources of pnp ready images?

Sent from my iPhone

> On 19 Oct 2016, at 21:50, David G Dixon <dixon at mail.ubc.ca> wrote:
> 
> I'm with Gordon.  Printing, transferring and etching is a piece of cake.  It
> requires a bit of practice, perhaps, but it's really not hard.  I can go
> from printed art to ready-to-stuff tinned board in about one hour.  I now
> use a laminator rather than an iron, and my transfers are coming out
> perfect. 
> 
>> -----Original Message-----
>> From: Synth-diy [mailto:synth-diy-bounces at dropmix.xs4all.nl] 
>> On Behalf Of Gordonjcp
>> Sent: Wednesday, October 19, 2016 1:30 PM
>> To: synth-diy at dropmix.xs4all.nl
>> Subject: Re: [sdiy] PC board from artwork?
>> 
>>> On Wed, Oct 19, 2016 at 04:03:39PM -0400, KA4HJH wrote:
>>> I need a PC board made from the artwork for this gadget:
>>> 
>>> http://www.astarcloseup.com/2016/02/the-oscilloscope-artist.html
>>> 
>>> The pdf file is here:
>>> 
>>> http://www.mediafire.com/view/5ubno26zci68ler/ScopeArt.pdf
>>> 
>>> Anyone? I made one years ago and I need to build a new one.
>> 
>> It's a single-sided board, just photocopy the relevant bit 
>> onto press-n-peel and etch your own.
>> 
>> --
>> Gordonjcp MM0YEQ
>> 
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> 
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy