[sdiy] Incremental encoder to up / down counter or pots and an ADC

[Tom Wiltshire]

+1 agree. This is a classic microcontroller job.

JP, what do you mean that these non-threaded shafts "get loose over time"? A non-threaded shaft is never going to be tight in the first place, is it? As long as the hole that that the encoder goes through is a nice tight fit, I don't see a particular problem (assuming the PCB is well supported). So what am I missing?

Thanks,
Tom


On 29 Nov 2016, at 16:44, Olivier Gillet <ol.gillet at gmail.com> wrote:

>> Is there a cheaper way to do this or is it easier to go back to using pots
>> and a flash ADC.
> 
> GPIOs and software, on any microcontroller.
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at synth-diy.org
> http://synth-diy.org/mailman/listinfo/synth-diy