[sdiy] Barron ringmod

[John Marshall]

It looks to me like a full wave clipper. The diodes are not in a ring but
are full wave bridge. The circuit will clip at the level of the zener plus
two diode drops.

Take care,
John

On Sat, May 21, 2016 at 11:17 AM, <thx1138 at earthlink.net> wrote:

> Hi BBob,
>
> Circuits from the ID perhaps?
>
> Perhaps I can build it up when I return from Europe trip Mid June.
>
> I have a bit of time towards end of June and am starting a new run of
> Modules in July.
>
> best regards,
>
> Terry Shultz
> thx1138 at earthlink.net
>
>
> On May 21, 2016, at 10:59 AM, bbob <fluxmonk at gmail.com> wrote:
>
> On a page about Bebe & Louis Barron, Barry Schrader includes what looks
> like a notebook page w/ an odd ring-mod schematic:
>
> http://www.barryschrader.com/blog/bebe_barron_1925_2008
> http://barryschrader.com.hostbaby.com/img/Bebe_Barron/Barron_Circuit.jpg
>
> Any ideas what's going on w/ the zeners in the middle of the ring? and the
> following opamp?
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20160521/ca6786d2/attachment.htm>