[sdiy] juno 6 parts

[synth]

No luck with doug.  Any other suggestions?




On Jan 14, 2016, at 3:10 AM, Jack Jackson wrote:

> Paging Doug from Synthparts.com...
>
> I believe from previous research that the sliders on Rolands of this  
> era are a bit special in that the slide levers are a bit longer and  
> of metal, rather than plastic construction. I think they were made  
> by Alps, but perhaps to Rolands specifications.
>
> Just to check, have you tried disassembling the slider and switch  
> and cleaning them?
>
> If you get a good modern substitute, I'd be interested to know
>
> Good luck!
> Jack
>
> ________________________________________
> From: Synth-diy <synth-diy-bounces at dropmix.xs4all.nl> on behalf of  
> synth <synthesizerdiy at gmail.com>
> Sent: 14 January 2016 01:57
> To: Sdiy List
> Subject: [sdiy] juno 6 parts
>
> Does anyone have a junker Juno 6 they are parting out?  Or might know
> some modern part numbers for the sliders and toggle switches?  I need
> the slider VR12.  It goes on the R position on the ADSR.  It should be
> 100K b.  Also need the 3 way toggle switch that goes in the LFO/ 
> Manual/
> ENV position for the DCO/PWM section.
>
> Thanks for any leads.
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy