[sdiy] juno 6 parts

[Jack Jackson]

Paging Doug from Synthparts.com...

I believe from previous research that the sliders on Rolands of this era are a bit special in that the slide levers are a bit longer and of metal, rather than plastic construction. I think they were made by Alps, but perhaps to Rolands specifications.

Just to check, have you tried disassembling the slider and switch and cleaning them?

If you get a good modern substitute, I'd be interested to know

Good luck!
Jack

________________________________________
From: Synth-diy <synth-diy-bounces at dropmix.xs4all.nl> on behalf of synth <synthesizerdiy at gmail.com>
Sent: 14 January 2016 01:57
To: Sdiy List
Subject: [sdiy] juno 6 parts

Does anyone have a junker Juno 6 they are parting out?  Or might know
some modern part numbers for the sliders and toggle switches?  I need
the slider VR12.  It goes on the R position on the ADSR.  It should be
100K b.  Also need the 3 way toggle switch that goes in the LFO/Manual/
ENV position for the DCO/PWM section.

Thanks for any leads.
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy