[sdiy] panning vca

[Rutger Vlek]

The CA3080 is known to be a bit noisy, but if you find it everywhere (even in the ground) I'd do a more fundamental check on your power supply and measurement setup.

How do you supply the board with power? How do you do the audio trace exactly? Just to be sure that the noise is actually in the board, not in the measurement method :).

Rutger



On 29 feb 2016, at 03:46, Joe wrote:

> Hello there, I built this panning VCA and I am happy with how it sounds
> except there is a lot of background noise. I tried to audio trace the
> noise but I find it everywhere, even in the ground plane. Is there some
> advice that someone can give me about how to isolate it. Thanks.
> 
> On Sat, 2016-01-23 at 12:58 -0500, Joe wrote:
>> Thanks to all! You guys are the awsomest ever! Joe.
>> 
>> 
>> 
>> 
>> On Fri, 2016-01-22 at 16:13 -0500, Joe wrote:
>>> I am planning on building this single as a panning VCA by Richard
>>> Curcio.
>>> 
>>> http://www.sdiy.org/richardc64/mmvca/index.html
>>> 
>>> I can source a CA3080 and since I am only building one I am not worried
>>> about expense. Here's the thing, I don't know what pot values to use for
>>> the trimmers and I am definitely thrown by the current controlling DC
>>> trimmer, though I understand how to wire it. Can anyone take a minute(or
>>> few) to help me figure them out? Thanks, Joe.
>>> 
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at dropmix.xs4all.nl
>>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>> 
>> 
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> 
> 
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy