[sdiy] STM32 vs WM8731

[Eric Brombaugh]

I've brought up a *lot* of systems with the WM8731 over the years. 
Getting the I2C control interface working can be a pain.

Your HAL I2C command looks right at first glance and the schematic seems 
OK too, so it's probably something else. One thing that you haven't 
described is what the physical construction approach is. On the WM8731, 
you'll notice that the MCLK input pin is right next to the I2C SCL pin - 
I've found that the I2C SCL input is *extremely* sensitive to crosstalk 
from the MCLK signal and if you built this on a solderless breadboard, 
or with flying wires from the MCU to codec then you can easily swamp it 
out to the point where you get no ACKs.

If you have a scope with high impedance probes, look at the SCL input 
pin - if you see MCLK there at a low level, it's a good bet your WM8731 
can't hear the I2C bus due to the crosstalk. Reroute the signals or put 
a simple RC lowpass filter on the MCLK to mitigate that.

Eric


On 02/16/2016 01:37 AM, Rob wrote:
> Just continuing on the STM32 discussions…
>
> I’ve been trying to get a Nucleo-F411RE talking to a WM8731, but not
> having much luck getting it to communicate over I2C
>
> I send the following from the STM32:
>
>                  WM8731Status[0] = HAL_I2C_Master_Transmit(&hi2c1, 0x34,
> WM8731PowerOn1, 1, 10000);
>
> But I don’t get an Ack from the WM8731:
>
> https://www.dropbox.com/s/yhen98n17pyrqgr/Screenshot%202016-02-16%2008.22.15.png?dl=0
>
> Here’s the schematic for the WM8731 setup:
>
> https://www.dropbox.com/s/e6fkerkmf95ldzf/Screenshot%202016-02-16%2008.20.29.png?dl=0
>
> I’m pretty sure everything on the STM32 side is setup correctly, and I’m
> working on the assumption that there’s not a lot to do with the WM8731.
> Once all the power is connected and the I2C mode and address pins are
> set low it should just receive I2C messages. I think the issue might be
> around the address, but I’ve tried all combinations I can think of.
>
> Any help would be much appreciated as my wife is getting tired of me
> shouting at the darn thing!
>
> Many thanks in advance
>
> Rob
>
> gmsn.co.uk
>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>