[sdiy] IDC Header 'cover'

[rsdio at audiobanshee.com]

As Florian implied, foam can be conductive. I assume the same with polystyrene. This could pose a serious problem when installed over a connector.

Brian

On Feb 2, 2016, at 10:14 AM, Tom Wiltshire <tom at electricdruid.net> wrote:
> Yeah, I was thinking some sort of foam too. Any sort of actual connector is going to cost real money. A bit of foam would be peanuts. Jam a piece of polystyrene on it.
> 
> On 2 Feb 2016, at 14:19, Florian Anwander <fanwander at mnet-online.de> wrote:
>> Am 02.02.2016 um 15:08 schrieb Justin Owen:
>> 
>>> Don't want to jumper or connect pins or have it act as any type on inter-board
>> 
>> Put a jumper on it, but only on one side
>> If minor resistance is not disturbing: stick some piece of antistatic foam on it.