[sdiy] Pot linearity towards extremes

Rutger Vlek rutgervlek at gmail.com
Wed Dec 14 17:03:43 CET 2016


Hi list,

I'm working on what's basically a continuous pot turned into a 16-position switch. It's a circuit that uses a simple free-running ADC to convert a 0 to 5V output from a potentiometer digital outputs that control switching of a 16-way CMOS switch and a 16-way LED driver. The led driver lights a LED in a ring of 16 around the pot to indicate the selected position. However, in the prototype the LED being lit doesn't line up with the position of the pot. The pot is a 10K linear one, but from my measurements it seems it is non-linear towards the extremes. The angle of physical rotation doesn't line up so well with the angle over which the resistance changes linearly. Is that a common property of pots? I hadn't seen it so clearly before. Any ideas on how to easily overcome it without needing both a gain and offset trimmer in the circuit?

Regards,

Rutger





More information about the Synth-diy mailing list