[sdiy] Analog Mux IC - pin compatible to CD4051 with +/-15V rails ?

[David G Dixon]

Short answer: no.  Just rewire or relayout for the superior DG chip. 

> -----Original Message-----
> From: Synth-diy [mailto:synth-diy-bounces at dropmix.xs4all.nl] 
> On Behalf Of sleepy_dog at gmx.de
> Sent: Thursday, July 28, 2016 7:12 PM
> To: synth-diy at dropmix.xs4all.nl
> Subject: [sdiy] Analog Mux IC - pin compatible to CD4051 with 
> +/-15V rails ?
> 
> Hey there,
> 
> the CD4051, analog mux: 8 inputs to 1 output (or vice versa), 
> with the highest supported supply rails I found was for +/- 7.5V.
> I realized what where I have that part in a circuit, the 
> voltages can be higher than that.
> Now I found the DG408 which supports +/- 20V rails, but it's 
> not pin compatible, so I'd have to reroute quite a bit.
> 
> Is there a 4051 pin compatible IC which supports +/- 15V rails?
> 
> regards,
> Steve
> 
> 
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy