[sdiy] VCO CV summer

Stewart Pye stewpye at optusnet.com.au
Mon Sep 14 08:37:25 CEST 2015


Yes, it's like a summers day here in Queensland today.

Stew.


On 9/14/2015 7:02 AM, Adam Inglis wrote:
> I think Stew might still be in Queensland, where it is starting to warm up nicely thanks!
>
> Adam
>> On 14 Sep 2015, at 5:46 am, Mattias Rickardsson <mr at analogue.org> wrote:
>>
>> Hurry up with your CV summer, it's already turning into CV autumn and
>> then you'll have to wait for next year. ;-)
>>
>> /mr
>>
>>
>> On 12 September 2015 at 11:14, Stewart Pye <stewpye at optusnet.com.au> wrote:
>>> Hi David,
>>>
>>> OK. I'll probably have a ground plane around it.
>>>
>>>
>>> Regards,
>>> Stewart.
>>>
>>>
>>>
>>> On 9/12/2015 8:57 AM, David G Dixon wrote:
>>>> I don't see a problem with it.  Just don't run it in parallel with
>>>> anything
>>>> that could bleed onto it.
>>>>
>>>>> -----Original Message-----
>>>>> From: synth-diy-bounces at dropmix.xs4all.nl
>>>>> [mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of Stewart Pye
>>>>> Sent: Friday, September 11, 2015 3:09 PM
>>>>> To: synthdiy diy
>>>>> Subject: [sdiy] VCO CV summer
>>>>>
>>>>> Hi,
>>>>>
>>>>> I'm designing a small VCO core PCB that I can plug in to
>>>>> different panel PCB's, so I can easily build VCO's with
>>>>> different features or for a different form factor without
>>>>> laying out the VCO core again. I'm wondering is it OK to have
>>>>> an inch or two of PCB trace from the op amp summing point to
>>>>> the summing resistors? It would make sense to have one CV
>>>>> input pin and have the summing resistors on the panel PCB,
>>>>> but I just want to make sure this won't cause problems...
>>>>>
>>>>> Regards,
>>>>> Stewart.
>>>>> _______________________________________________
>>>>> Synth-diy mailing list
>>>>> Synth-diy at dropmix.xs4all.nl
>>>>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>>>
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at dropmix.xs4all.nl
>>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>




More information about the Synth-diy mailing list