[sdiy] SSM2044 Frequency Range
Dan Snazelle
subjectivity at hotmail.com
Fri Sep 4 05:56:36 CEST 2015
Good luck !!! let me know if you want me to do any tests on my old 2044 module
Sent from my iPhone
> On Sep 3, 2015, at 11:43 PM, "Dan Snazelle" <subjectivity at hotmail.com> wrote:
>
> I got this from the designer of the 2044:
>
> ( He was nice enough to answer )
>
>
> "From what you said...is the guy using a real SSM2044 ? in which case he either has a defective 2044, or has used sub-standard (maybe leaky caps, for example) components. I don't see why the supply voltage would matter. In any case, a typical 2044 should far exceed the 1000:1 range.
>
>
>
> Without more data it's hard to debug. One critical question is - what does it do when it fails? I.e. what is the voltage at the important nodes in the circuit?
>
>
>
>
> Sent from my iPhone
>
>> On Sep 3, 2015, at 3:35 AM, "Tim Ressel" <timr at circuitabbey.com> wrote:
>>
>> Hi,
>>
>> I am getting about 85mV when running at 15 volt rails.
>>
>> I have tried chips I bought recently and chips bought quite a few years ago. My original 2044 filter used a chip from a long time ago and it has the same range issue.
>>
>> --tr
>>
>>
>>>> On 9/2/2015 5:38 PM, rsdio at audiobanshee.com wrote:
>>>> On Sep 2, 2015, at 5:21 PM, Tim Ressel <timr at circuitabbey.com> wrote:
>>>> I just built an SSM2044 based directly on the datasheet schematic. I'm using 12 volt rails. The frequency range is less than expected. The most I get is about 130:1, and when I adjust it for 1 volt/octave the range is about 100:1. Even when I run it on 15 volt rails I get about 370:1. This is far short of the 1000:1 the datasheet talks about.
>>>>
>>>> Any ideas?
>>> Do you see +/-90 mV at pin 13 when you vary the CV?
>>>
>>> How are you confirming the filter frequency cutoff?
>>>
>>> Do you have the entire circuit on page 54, including the Frequency Offset Adjust and the Control Summer?
>>>
>>> Brian
>>>
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at dropmix.xs4all.nl
>>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>> --
>> --Tim Ressel
>> Circuit Abbey
>> timr at circuitabbey.com
>>
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
More information about the Synth-diy
mailing list