[sdiy] Which solder is safer for home projects ?

[Neil Johnson]

"No clean" = no clean.

You only remove it for either (a) cosmetic reasons (which is a stupid
reason - you do more harm than good by scrubbing away at the board),
or (b) on specific areas where you have high-impedance low leakage
circuitry (think S&H).  Otherwise leave it alone and all will be well.

Neil

On 23 October 2015 at 14:09, Michael Zacherl <sdiy-mz01 at blauwurf.info> wrote:
>
> On 23.Oct 2015, at 14:50 , Roman Sowa <modular at go2.pl> wrote:
>
>> Use no clean flux, avoid water soluble ones.
>
> is there no cleaning at all with "no clean" solder or do you use e.g. isopropanol to rub off the board?
>
> --
> http://mz.klingt.org
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy



-- 
--
http://www.njohnson.co.uk