[sdiy] I need your knob expertise

[bbob]

i use shaft reducers:

http://www.mouser.com/ProductDetail/TE-Connectivity-Alcoswitch/KR104/?qs=sGAEpiMZZMuos25lhNoLaob%2fVzy5Skyq

allows me to use the same knobs on both 1/4 and 1/8 controls

On Thu, Oct 8, 2015 at 2:47 PM, MTG <grant at musictechnologiesgroup.com>
wrote:

> I'm looking for a relatively low profile knob for a rotary switch. 1/8"
> diameter shaft. The switch does seems to require some force to turn, so
> knob diameter should not be tiny. I don't know for sure yet, but probably
> >= 1/2" in diameter and about the same in height? It's for a retrofit mod
> that will appear on the outside of some NOT rare vintage gear.
>
> Curiously I have zero knob stock,  =:-o  so rather than just buy a pile of
> stuff to test off eBay, I thought I should ask here first.
>
> I'm using a Grayhill 4 position rotary switch ($$$) because it seems to be
> the only thing I can find that will fit in small places. Anyway it has a
> 1/8" shaft with "a bit" of a flat spot.
>
> http://www.mouser.com/ds/2/626/Rotary_56-335299.pdf
>
> GB
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20151008/8e0cbe41/attachment.htm>