[sdiy] I need your knob expertise
rick.jansen at xs4all.nl
Thu Oct 8 21:45:08 CEST 2015
I sense some innuendo...
> On 08 Oct 2015, at 21:17, bbob <fluxmonk at gmail.com> wrote:
> i use shaft reducers:
> allows me to use the same knobs on both 1/4 and 1/8 controls
>> On Thu, Oct 8, 2015 at 2:47 PM, MTG <grant at musictechnologiesgroup.com> wrote:
>> I'm looking for a relatively low profile knob for a rotary switch. 1/8" diameter shaft. The switch does seems to require some force to turn, so knob diameter should not be tiny. I don't know for sure yet, but probably >= 1/2" in diameter and about the same in height? It's for a retrofit mod that will appear on the outside of some NOT rare vintage gear.
>> Curiously I have zero knob stock, =:-o so rather than just buy a pile of stuff to test off eBay, I thought I should ask here first.
>> I'm using a Grayhill 4 position rotary switch ($$$) because it seems to be the only thing I can find that will fit in small places. Anyway it has a 1/8" shaft with "a bit" of a flat spot.
>> Synth-diy mailing list
>> Synth-diy at synth-diy.org
> Synth-diy mailing list
> Synth-diy at synth-diy.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Synth-diy