[sdiy] ATSamD4 Breakout Board

[Jim Patchell]

As if an answer to a prayer, Sparkfun has come through.

https://www.sparkfun.com/products/13664

That solves that.

-Jim


On 11/6/2015 3:39 PM, Jim Patchell wrote:
> I am sorry.  Not enough sleep lately.  The processor is actually the 
> ATSAMD21, not D4.  Not even sure where the D4 came from in my brain.
>
> On 11/6/2015 3:33 PM, Jim Patchell wrote:
>> I have been looking for a breakout/header board for the ATSamD4E 
>> microcontroller.  For those who don't know, ths is an ARM Cortex M0+ 
>> processor.  I am interested in the one that has 64K of flash and 8KB 
>> ram.  But so far, I have found nothing, so, I am starting to think 
>> about designing my own.  The intended purpose is to use this in 
>> projects that need a MIDI interface, be it the traditional one using 
>> a serial port or a USB port (this part has USB).  Other features of 
>> the part are it has an I2S audio interface, I2C, SPI, UART, Non 
>> Maskable Interrupt.  The form factor I am thinking about is a Dip 
>> Header, and the price point I am going to target to is $20.  I should 
>> mention that you can get this part on an Atmel Explained Eval Board 
>> for $42, and the Arduino Zero for $38.  I was wondering if there was 
>> any interest in this project?
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>