[sdiy] Reality versus simulation?

Walker Shurlds walkershurlds at gmail.com
Fri Nov 27 17:22:59 CET 2015

If this is what you are seeing: https://flic.kr/p/BzkdV8

Then it is because the oscope's f axis is linear instead of logarithmic.

I got this in LTSpice when I changed the axis to linear.



On Fri, Nov 27, 2015 at 9:50 AM, Walker Shurlds <walkershurlds at gmail.com>

> Probe capacitance is the first thing I thought also. In addition, the relatively low impedance of the circuit could be shifting the oscope's pole(s) into a lower frequency. 
> Another factor could just be windowing selection from the fft, or maybe the axes aren't logrithmic but are in spice, this only affects whether the response *appears* flat, of course. A few extra pictures might help with diagnosis.
> Walker
> On Fri, Nov 27, 2015 at 9:09 AM, Sarah Thompson <plodger at gmail.com> wrote:
>> Another possibility would be stray capacitance from the breadboard itself causing loss at higher frequencies. Also, are you using a X1 or a X10 scope probe? If you are using X1, this might be the culprit, though 20kHz is a bit low to start seeing much difference there.
>> As an experiment, try putting opamps before, after and between the stages just configured as voltage followers. This will greatly reduce the distance any high impedance signals need to travel, and tends to make filter weirdness go away. I'm not necessarily suggesting this for a production version, but sometimes going for overkill then backing off is less pain. 
>> Sarah
>> Sent from my iPad
>>> On Nov 27, 2015, at 5:30 AM, Tom Wiltshire <tom at electricdruid.net> wrote:
>>> As per schematic, +/-10% for the caps, +/-1% for the resistors.
>>> Values wobbling about would shift the cutoff points a bit, but shouldn't give the significant downhill slope I'm actually seeing. Should it?
>>> For example, RC variations give me a lowpass cutoff of supposedly 28.4KHz, but actually 25.6 kHz – 31.9 kHz.
>>>> On 27 Nov 2015, at 11:52, Neil Johnson <neil.johnson71 at gmail.com> wrote:
>>>> Tom,
>>>>> So what's going on with the real-life filters? Can I improve their performance?
>>>> What are the actual values of the capacitors and resistors in your circuit?
>>>> Neil
>>> _______________________________________________
>>> Synth-diy mailing list
>>> Synth-diy at synth-diy.org
>>> http://synth-diy.org/mailman/listinfo/synth-diy
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at synth-diy.org
>> http://synth-diy.org/mailman/listinfo/synth-diy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://synth-diy.org/pipermail/synth-diy/attachments/20151127/9431b57e/attachment.html>

More information about the Synth-diy mailing list