[sdiy] Notching pliers needed for resistors and caps legs..

[Jean-Pierre Desrochers]

No problem.

Le 2015-05-21 06:11, Michael Zacherl a écrit :
> On 20.May 2015, at 20:54 , Jean-Pierre Desrochers <jpdesroc at oricom.ca> 
> wrote:
> 
>> The component type in the early post's photo
>> didn't matter.. cap or fuse I didn't care.
>> What interested me was the bended leads..
> 
> I think Tom was aware of that, as well as I am. So no harm meant!
> I also was focused on the tool-question so I didn't realise until Tom 
> mentioned.
> Had to look it up and posted the result.
> I see I could have put this line into my original reply, sorry!
> 
>> But thanks anyway.
>> 
>> Le 2015-05-20 14:47, Michael Zacherl a écrit :
>>> On 20.May 2015, at 17:36 , Tom Bugs <admin at bugbrand.co.uk> wrote:
>>>> Sure that's a resettable fuse, not a cap...
>>>> (glad others have had more helpful replies!)
>>>> On 20/05/2015 15:57, Jean-Pierre Desrochers wrote:
>>>>> Can anybody help me find a tool, pliers that can 'squeeze' a notch
>>>>> on component leg to keep it raised up from a PCB for heat reason ?
>>>>> Final notches would look like this on a cap:
>>>>> http://d1gsvnjtkwr6dd.cloudfront.net/large/PA-PTC-750_LRG.jpg
>>> http://pdf.datasheetarchive.com/indexerfiles/Datasheet-091/DSA0031788.pdf
> 
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy