[sdiy] Loctite 648 on fader knobs?

Rob Spencer Rob at gmsn.co.uk
Fri May 15 10:30:48 CEST 2015


The gaps are very small, there's no play in them, they just fall of if it's turned upside down.

I'll try PTFE tape if the Loctite didn't work.

Cheers

Rob

> On 15 May 2015, at 08:53, Maarten <diy at artefacts.nl> wrote:
> 
> Loctite 648 is for small gaps( <0.15mm), it will probably not cure if the gap it to big. Glue in general works great but makes it impossible to replace the fader.
> The tape solutions seems to be the best option, I use tape used for gas and water, it has no adhesive and stays elastic over time.
> 
> Rob Spencer schreef op 14-5-2015 om 20:30:
>> Hi,
>> 
>> I've recently replaced some faders and the new ones have a slightly smaller shaft, so the knobs don't quite stay on.
>> 
>> I'm thinking of using a small dot of  Loctite 648 but wanted to know if there's a better solution?
>> 
>> Many thanks in advance
>> 
>> Rob
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy



More information about the Synth-diy mailing list