[sdiy] Round pin 0.1" headers

[MTG]

"Machined"

On 3/1/2015 7:37 AM, Richie Burnett wrote:
> I think "Turned pin header" might be the phrase you're looking for :-)
>
> -Richie,
>
> -----Original Message----- From: Tom Wiltshire
> Sent: Sunday, March 01, 2015 3:26 PM
> To: synthdiy diy
> Subject: [sdiy] Round pin 0.1" headers
>
> Hi All,
>
> Does anyone know of a source of round pin 0.1" headers suitable for
> making daughter boards? The usual square pin ones are great, and fine on
> a breadboard, but the pins are slightly too large to fit into an IC
> socket, so they're not so good for this application. I'd like something
> that would allow me to pull a 40-pin DIP uP out of its socket and stick
> a replacement daughter board in instead.
>
> Thanks,
> Tom
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2014.0.4800 / Virus Database: 4257/9206 - Release Date: 03/01/15
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>