[sdiy] Connector Q

[Jarno Verhoeven@ziggo.nl]

I haven't seen this connector before, but the partnumber looks like a AMP/ Tyco/
TE partnumber.


> Op 12 juni 2015 om 15:53 schreef Richie Burnett
> <rburnett at richieburnett.co.uk>:
>
>
> Have seen many electrical connectors over the years, but never one of those!
> Have you checked in case there's any manufacturer's marking or part no. on
> the side of the moulding that's currently against the PCB?
>
> Does the PCB footprint have the same pitch as a D-sub connector? Maybe you
> could replace it with a D-sub pair on that PCB and whatever board it mates
> with?
>
> The only other thing I can suggest is to get a load of Samtec/Molex/Amp/etc.
> catalogues and thumb through those, or show that picture to a rep next time
> they're in.
>
> Best regards,
>
> -Richie,
>
>
> -----Original Message-----
> From: Colin f
> Sent: Friday, June 12, 2015 10:17 AM
> To: '*SYNTH DIY'
> Subject: [sdiy] Connector Q
>
> Any of you guys know of a source for this type of connector, or even just
> who made it ?
> http://www.colinfraser.com/connectr.jpg
>
> It's like a D-sub with blade contacts, used on Yamaha FX-1 cards.
>
> TIA,
> Colin f
>
>
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2014.0.4800 / Virus Database: 4311/10001 - Release Date: 06/12/15
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy