[sdiy] Juno 60 woes

[Jack Jackson]

On the Panel CPU it is, but not on the CPU board.

----------------------------------------
> Date: Wed, 3 Jun 2015 22:09:00 +0100
> From: gordonjcp at gjcp.net
> To: synth-diy at dropmix.xs4all.nl
> Subject: Re: [sdiy] Juno 60 woes
>
> On Wed, Jun 03, 2015 at 08:26:59PM +0100, Jack Jackson wrote:
>> Hey, thanks for the reply.
>>
>> I added the reset circuit as you suggested, but still no luck. I've checked the keyboard matrix scanning lines (going into the 74LS42 from the CPU) and only some of them are active, suggesting the CPU is not behaving properly. The interrupt (INT) line on the CPU (coming from the patch board CPU) is constantly at 0V and it is active low. So i think some input to the CPU is not behaving properly and causing it to get locked in this state.
>>
>> Any more ideas guys?
>
> Isn't /INT used for the memory protect switch?
>
> --
> Gordonjcp MM0YEQ
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy