[sdiy] Minimoog non-linear keyboard response

Eric Frampton eric at ericframpton.com
Thu Jul 23 06:15:01 CEST 2015

…or “unevenly exponential” might be a better way to put it.

If I can get the A’s on each end of the keyboard to scale up perfectly for each oscillator, and I can get the octaves on all three oscillators to switch evenly, what would cause the internal intervals between those A’s to not be linear? In other words, if A1 and A4 are correct, A2 might be a little sharp and A3 might be a little flat, but it’s enough of a deviation that when switching octaves, the oscillators don’t stay in tune with each other.

The same situation happens whatever octave it’s in - the keyboard itself seems to be triggering non-linearly (non-exponentially) internally, no matter where the tuning on a given oscillator is set. If the ends are right, the middle is wrong.

I’ve got a buffer board installed, so I don’t think it’s that.

Thoughts? Time for new resistors on the actual pratt-read assembly? Or was this what the field service mod on the keyboard PCB was supposed to solve?


More information about the Synth-diy mailing list