[sdiy] TR 606 Din Sync problem

Adam Inglis 21pointy at tpg.com.au
Sun Jul 12 03:00:59 CEST 2015

Re-solder all the pins where the jack mounts on the board - mine have  
cracked several times, the cracks are only visible under stress.

On 12/07/2015, at 10:00 AM, Edward Schultheis wrote:

> Hi all, my 606 used to sync to my XoX with no problems until recently.
> At first it seemed to short out, but by jiggling the cable is get it  
> working. Now it has stopped completely.
> The clock appears to work, as well as the reset, but not the Start/  
> Stop.
> I figured that it was a short on pin 1.
> I found a trace was bad, and bridged that, but it is still not  
> working.
> When I slave the 606 I see the led go on indicating that it is  
> receiving the signal, and it turns off when stopped.
> When I slave the Xoxbox I also see the same, as well as what appears  
> to be the clock rate.
> Does anyone know of another reason the start stop has stopped working?
> Is there a way to test the signal like we can with a midi signal?
> Thanks all!
> Edward Schultheis
> Sent from me!
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

More information about the Synth-diy mailing list