[sdiy] sh09 cv out drops again

[Carlos Portela]

The psu was checked, no leakage on the keyboard contact. Dont know
what you mean with flux
It has no guard ring on the pcb around LF13741, but datasheet talks
about that. It has a cardboard with metal foil connected to ground
above this area.
The hold is not holding (a semitone down every 15 sec). When the key
is pressed no pitch drop, only when it is on VCA HOLD
I didnt replaced all components components at same time, otherwise I
could not track the problem.
I had the opportunity to clean the the board area, all contacts in the
area were re-soldered.



2015-01-14 8:57 GMT+01:00 Roman Sowa <modular at go2.pl>:
> Just an idea: clean the board in area of FET-CAP-OPAMP
> Soldering might have evaporated all water from the flux/dust/chewinggum that
> is there, and later air humidity helped the dust conducting.
>
> Roman
>
> W dniu 2015-01-13 o 20:01, Carlos Portela pisze:
>>
>> Hi all,
>>
>> After 2 months I turn the sh09 on and the cv out/pitch drops when it
>> is on VCA hold.
>>
>> Replaced IC2 lf13741 by CA3140, the fat capacitor, and IC1 4558 with
>> TL072. the problem persist.
>>
>> Again removed the 2x 2sk30A GR to test them. After re-solder them the
>> pitch was stable.
>> I found that's (maybe) because of the heat from the iron.
>> 10 min later was drooping again.
>>
>> Also checked the sample and hold from lfo section (last time I
>> switched the sample n hold FET with the keyboard tracking FET) and
>> there was a kind of portmento between the played notes...
>>
>> Any ideas what might be causing this? Bad Fets?
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy