[sdiy] Cleaning PCBs in Ultrasonic Baths

[Richie Burnett]

You need to be careful with some parts in U/S cleaning baths.  Tuning fork 
(32.768kHz) watch crystals are susceptible to damage from what I can 
remember.  There may be other susceptible components too?

-Richie,


-----Original Message----- 
From: Rob Spencer
Sent: Tuesday, December 15, 2015 12:46 PM
To: synth-diy at dropmix.xs4all.nl
Subject: [sdiy] Cleaning PCBs in Ultrasonic Baths


I’m pretty sure it is okay to do this, but just wanted to check with you 
guys first, but is it okay to clean flux from PCBs after the SMD chips have 
been soldered?

If so, what settings? About 65DegC? On the delicate setting for about 30 
mins?

Many thanks in advance.

Rob Spencer
gmsn.co.uk
07590 267835





_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy








No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.7294 / Virus Database: 4483/11182 - Release Date: 12/15/15