[sdiy] <OT> Job status, plastic repair

[Barry Klein]

First off, I was laid off at WDC with a couple hundred or so others 
yesterday.  Severance package not so bad - for being there 25 years just 
last month.
So as a result, my barry.l.klein at wdc.com email is no longer - just get me at 
barryklein at cox.net.  Please advise how I can shut down the synth_DIY 
subscription to the WDC address (or will the system see the bounces and take 
care of it?)
Also, as a result, I have lost my "publisher" for the few Electronic Music 
Circuits (and Databooks) I send out.  I was getting them printed by the WDC 
copy center at a low enough cost to make it worthwhile taking the effort.
I only have a few left and not anxious to get more printed as without a 
website few even learn about it.  Hopefully an electronic version coming in 
the future.
I recently met a guy that uses Amazon Createspace to print his books (about 
the same number of pages) and he sells the finished copies for $15 each.  It 
would cost me that to print one now...

I still haven't gotten back to the Andromeda, but I suspect it will produce 
sound etc.  Guess what - I bought another one.
This one has the same fault.  I switched out the resonator with an xtal but 
haven't tried it yet.  This one had a ton of dust inside!  A few of the 
plastic end cap mounting standoffs were broken.
What do you guys recommend for a plastic glue for these?  I never have had 
any luck with plastic glues or epoxies.  None of them actually melt the 
plastic and form a bond.

Barry