[sdiy] FS: MicroKorg replacement keybed

[Nantonos]

Hello Mike,

Wednesday, October 1, 2014, 9:48:23 PM, you wrote:

> On Wed, 2014-10-01 at 11:50 -0700, MTG wrote:
>> You might find some SCI Pro One user that can adapt that for use. Are 
>> the keys normal width?

> Thanks Grant,

> The octaves are 136mm and the keys are 80mm tall (not counting the hinge
> area at the top that would normally be hidden).

Since you have one, what is it like on the back? What sort of switches
are used and what are the connections?

The syntaur website just shows the front. Which is fine if one is
buying it for the stated purpose.

I vaguely wondered about getting two, if they could be converted into
a single 73-key (six-octave) small-sized keybed. This is because the
Ondes Martenot used smaller-than-standard keys (though I don't have an
exact measurement) and I'm gradually putting together an analog
synth-based OM.

Or I could gut a microKEY 61 I suppose, but that is only five octaves.

-- 
Best regards,
 Nantonos                            mailto:nantonos at epona.net