[sdiy] Measuring Vpp

Neil Johnson neil.johnson71 at gmail.com
Thu Jun 12 14:13:58 CEST 2014


Nicholas Keller wrote:
> ... it's a Craftsman from a few years ago, probably less than 7 years old.  Has Hfe, temp, freq, as well as all the basic features found on most DMMs, but I've never seen Vrms nor dB on it or in the manual.  Perhaps I never noticed because I never needed it.

Unlikely to be a true RMS reading meter then, and AC measurement
frequency range could suck a bit.  Fine at line frequency (50/60Hz).
I guess if you run the TTSH at that frequency then the readings will
be good enough - but check the manual to see what the meter's initial
accuracy was.

Neil



More information about the Synth-diy mailing list