[sdiy] Oberheim TVS Keyboard scaling

[Terry Shultz]

Hi Folks,
On this 2-Voice unit. We are talking about the Digital Version vs. 
Analog TVS-1a?

I was digging out my schematics to take a look and remembered we built 2 
flavors of KBD. Controllers and 2 different flavors of the Mini-Sequencers.

just checking to make sure I read your question about the TVS-1A 
Keyboard correctly.

best regards,

Terry Shultz


On 7/30/2014 2:51 AM, Roman Sowa wrote:
> I would start checking all the 4030 gates in the keyboard scanner. If 
> one of them is faulty, few notes will play wrong tune while most of 
> the keyboard range is OK.
> Just my wild guess at this time...
>
> Roman
>
> W dniu 2014-07-30 09:29, gm pisze:
>> So I'm doing the usual SEM repairs on a Two-Voice --
>> get to the final testing stage & notice that, while the oscillators on
>> both SEMs track correctly in Unison mode, the two SEMs are several
>> semitones out in Duophonic mode.  Further testing reveals that while I
>> can get a three volt range from the bottom of the keyboard to the top,
>> the third C is flat (along with several keys around it).
>>
>> There are only two trimmers on the digital keyboard control module; does
>> anyone know the correct procedure for scaling this thing?  All supply
>> voltages (+/-18.5, +/-10, +9) are present and correct;  would like to
>> eliminate the scaling as a cause for this before I start looking for
>> other repair options.
>>
>> Thanks.
>> ~GMM
>> _______________________________________________
>> Synth-diy mailing list
>> Synth-diy at dropmix.xs4all.nl
>> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>
>