[sdiy] Solder stops flowing all of a sudden?

Karl Ekdahl elektrodwarf at yahoo.se
Wed Jan 22 00:21:59 CET 2014


i'm using no-clean sac 305 which i assume means it has no-clean flux on it from scratch, i guess part of it may be missing the flux? bummer, this shit's expensive..





Den tisdag, 21 januari 2014 18:19 skrev charlie wallace <charlie at finitemonkeys.com>:
lack of flux?

On Tue, Jan 21, 2014 at 3:09 PM, Karl Ekdahl <elektrodwarf at yahoo.se> wrote:
> Hi list, so i've stumbled on this peculiar thing where my solder stops flowing all of a sudden. It melts, but doesn't become liquid, it sort of becomes "old" immediately the way solder becomes if its been on your tip for too long - giving horrible crack-ily joints. It seems my iron is keeping its heat and the tip is brand new, i seem to recall stumbling upon this before and it was a roll of solder that was bum halfway through.. rings any bells? Not sure what to do, buy another roll of solder? Is my iron going?
>
> Thanks
>
> Karl
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy

_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy




More information about the Synth-diy mailing list