[sdiy] mounting brackets for potentiometers

[Rkm]

Thanks for the information!

Currently I'm using alpha 6mm pots with a 9mm wide body, but I've got a list of changes for the next round of boards, so I'll look into the pots with the 16mm bodies.

-Richard


Sent from my iPod

On Aug 10, 2014, at 5:54 AM, "Mike Gorman" <mikegorman at btinternet.com> wrote:

> I'm not sure where you are based, but if in Europe, it might be worth having
> a look at CESYG, here:
> http://cesyg.synth.net/page/products/accessories/16mm-pot-bracket/
> 
> This is the commercial site from Mr Neil Johnson from around this list.
> 
> Regards
> 
> Mike
> 
> -----Original Message-----
> From: synth-diy-bounces at dropmix.xs4all.nl
> [mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of Richard Moore
> Sent: 10 August 2014 02:41
> To: Synth-diy Diy
> Subject: [sdiy] mounting brackets for potentiometers
> 
> Electronics wizards, I have a question:
> 
> I'm designing a small board to go into a guitar body, so I have to match the
> potentiometers' shaft length, diameter, threading and knurling to what's
> already there.  I've found such pots, but they don't have mounting brackets
> to allow the pots to support the weight of the board.  Are there right angle
> board mounting brackets that I can add to 6mm/0.25 inch potentiometers?
> 
> Thanks,
> Richard
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>