[sdiy] mounting brackets for potentiometers

[Mike Gorman]

I'm not sure where you are based, but if in Europe, it might be worth having
a look at CESYG, here:
http://cesyg.synth.net/page/products/accessories/16mm-pot-bracket/

This is the commercial site from Mr Neil Johnson from around this list.

Regards

Mike

-----Original Message-----
From: synth-diy-bounces at dropmix.xs4all.nl
[mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of Richard Moore
Sent: 10 August 2014 02:41
To: Synth-diy Diy
Subject: [sdiy] mounting brackets for potentiometers

Electronics wizards, I have a question:

I'm designing a small board to go into a guitar body, so I have to match the
potentiometers' shaft length, diameter, threading and knurling to what's
already there.  I've found such pots, but they don't have mounting brackets
to allow the pots to support the weight of the board.  Are there right angle
board mounting brackets that I can add to 6mm/0.25 inch potentiometers?

Thanks,
Richard
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy