[sdiy] mounting brackets for potentiometers

[Paul Burns (Fitvideo)]

This might give you some ideas

http://liivatera.com/Products/prototyping/Bracket/#3

it partners with this prototyping board

http://liivatera.com/Products/prototyping/EuroProto/#3

regards

Paul

-----Original Message-----
From: synth-diy-bounces at dropmix.xs4all.nl
[mailto:synth-diy-bounces at dropmix.xs4all.nl] On Behalf Of Richard Moore
Sent: 10 August 2014 02:41
To: Synth-diy Diy
Subject: [sdiy] mounting brackets for potentiometers

Electronics wizards, I have a question:

I'm designing a small board to go into a guitar body, so I have to match the
potentiometers' shaft length, diameter, threading and knurling to what's
already there.  I've found such pots, but they don't have mounting brackets
to allow the pots to support the weight of the board.  Are there right angle
board mounting brackets that I can add to 6mm/0.25 inch potentiometers?

Thanks,
Richard
_______________________________________________
Synth-diy mailing list
Synth-diy at dropmix.xs4all.nl
http://dropmix.xs4all.nl/mailman/listinfo/synth-diy



-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4744 / Virus Database: 4007/8008 - Release Date: 08/09/14