[sdiy] breadboard, was: Minimum spacing between 1/4" jacks on DOTCOM modules..

[cheater00 .]

Even if I don't have the space for that, I think David is making a
good argument for his method.


What about different solderless breadboards - has anyone noticed
differences? Why do some cost so much more than the others?

Cheers,
D.

On Mon, May 20, 2013 at 5:35 AM, David G Dixon <dixon at mail.ubc.ca> wrote:
>> I also find breadboard to be far easier than dealing with
>> making circuit boards (drilling holes for 10-20 quad opamps
>> sounds like an absolute nightmare).
>
> Like anything else, with the proper tools its a snap.  The key is to create
> tiny little holes in the centre of your pads in the layout which are etched
> away.  These holes act as guides of the drill bit, so your aim doesn't need
> to be perfect.  However, with a drill press and some fine numbered drill
> bits (I use #68 for most holes), you can drill 100 holes very quickly,
> especially on my layouts, which conform to a strict 0.1" grid.
>
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy