[sdiy] DSP 808 demo

Gordon JC Pearce gordonjcp at gjcp.net
Wed Jul 24 09:44:02 CEST 2013

On Tue, Jul 23, 2013 at 03:55:20PM -0700, rsdio at sounds.wa.com wrote:

> What about the surface mount parts? I love designing with SMD, but I
> hate even the thought of trying to solder them by hand. Are most
> kits a combination of an assembled board and parts for the front
> panel, knobs, and wiring for the kit builder?

It would be fine if it was *all* SMD.  Through-hole is far too fiddly and difficult to hand-solder, especially at home.

If it's through-hole, I just take it into work and use all the special kit there.

Gordonjcp MM0YEQ

More information about the Synth-diy mailing list