[sdiy] Roland M-16C Memory Cartridge

[Jack Jackson]

I was thinking of using these guys.

http://www.3dprint-uk.co.uk/portfolio/materials/

They only use white nylon, and you can see in the video that it's not at all brittle and very strong!
Thickness could definitely be thin enough for this application.
________________________________
> Date: Mon, 2 Dec 2013 14:55:07 +0100 
> Subject: Re: [sdiy] Roland M-16C Memory Cartridge 
> From: cheater00 at gmail.com 
> To: jackdamery at hotmail.co.uk 
> CC: synth-diy at dropmix.xs4all.nl 
> 
> 
> On 2 Dec 2013 14:51, "Jack Jackson" 
> <jackdamery at hotmail.co.uk<mailto:jackdamery at hotmail.co.uk>> wrote: 
>> 
>> Why couldn't one just 3D print the case rather than injection mold 
> it? I understan the screw holes might be difficult, but one could omit 
> them. 
>> It doesn't look so complicated. 
> 
> The structure needs to be very thin, rigid, and plastic. A printed part 
> would be too thick and would shatter easily. The connector is even 
> worse. 
> 
> D.