[sdiy] Dotcom synth supply rails harness suggestions needed...

[Oscar Salas]

Hello,

> I was thinking of using a PCB with large traces close to the supply
> voltage outputs
> that would interconnect the main supply voltages to all
> the modules supply cables. But now I wonder if should use 2 rows of
> 22 x MTA156 TYCO part# 640445-6 connectors on this PCB
> and connect them using crimped cables with MTA156 part# 3-643819-6 on each
> of their sides
> or
> if I should solder one side of each cable to that PCB and their
> other sides would be crimped..
> The thing that would help a lot would be pictures of some
> DIY Dotcom system's slant cabinet (rear view) or any suggestions..
> Thanks !
> J-Pierre

I think that it is more neat and useful the first option.
I did a PCB board distribution for the 4 pin 3.96 pitch connectors. Maybe
you can do a similar thing for your connectors.
http://electronic-sea.net/power_distribution_board.html


electronic-sea.net