[sdiy] Adjusting bender range in JX8P

[Gil W.]

Just for the record - it was caused by low than usual supply voltages (+12/-12 instead of +15/-15).







--- On Fri, 9/14/12, Gil W. <gil_we at yahoo.com> wrote:

> From: Gil W. <gil_we at yahoo.com>
> Subject: [sdiy] Adjusting bender range in JX8P
> To: "synth-diy at dropmix.xs4all.nl" <synth-diy at dropmix.xs4all.nl>
> Date: Friday, September 14, 2012, 12:10 PM
> I noticed that in my JX8P the bend
> range adjustment is not correct - meaning that if you set
> the Bend Range slider to maximum, it will bend a half note
> less than what it should - for example bending the C note
> fully up, will play F# instead of G.
> 
> I looked at the service manual and found nothing regarding
> to an  adjustment for this function... any idea ??
> _______________________________________________
> Synth-diy mailing list
> Synth-diy at dropmix.xs4all.nl
> http://dropmix.xs4all.nl/mailman/listinfo/synth-diy
>